Skip to the content

Water Heater Repair in Lubbock, TX

If you have no hot water, the tank is leaking or the water heater is making loud noises, we can send a local plumber to repair it.

Tank water heater in a laundry closet ready for water heater repair

What to do if your water heater is leaking

A leaking tank is the water heater problem to deal with today

  1. Close the cold water valve

    Find the valve on the cold water pipe going into the top of the tank and turn it clockwise.

  2. Turn off the heat

    Switch off the breaker for an electric water heater. On a gas model, turn the control knob to pilot or off.

  3. Stay back from the water

    The water in the tank can be scalding. Let it cool before you clean it up.

A drip from a pipe connection or fitting is usually a simple repair. Water leaking from the tank itself, or rust stains running down the outside, almost always means the tank has rusted through. Our plumbing emergency steps cover what to do next.

Common water heater problems and their causes

Water heater repair in Lubbock usually starts with a problem you can describe in a sentence. Find yours in the table below.

What you noticeLikely causeWhat to check first
No hot water at allThe pilot light is out, the breaker tripped or a heating element failedThe pilot window or the breaker panel
Hot water runs out quicklySediment buildup or a failed lower heating elementWhether it gets worse each week
Popping or rumbling noisesMineral sediment on the bottom of the tankHow old the water heater is
Brown water or a rotten egg smellA worn anode rod or rust inside the tankWhether the cold water is clear
Water around the baseA fitting, the relief valve or the tank itselfWhere the water starts
Water dripping from the relief valvePressure is too high or the valve is wornLeave this one to a plumber

Water heater checks to try before you call

  • Gas water heaters

    Look through the small window near the bottom of the tank to see whether the pilot flame is lit.

  • Electric water heaters

    Find the breaker, switch it fully off and then back on, once only.

  • The temperature dial

    Check that nobody has turned the dial down by accident.

  • The cold water valve

    Make sure it was not left partly closed after earlier work.

A breaker that trips a second time, or a pilot light that keeps going out, means a plumber needs to find the fault. If you smell gas near the water heater, get out of the house and phone the gas company from outdoors.

Control knob and pilot window near the bottom of a gas water heater

Repair your water heater or replace it?

Many calls for water heater repair in Lubbock come down to one worn part. On gas models that is often the thermocouple or the gas control valve, and on electric models a heating element or its thermostat. In other cases the tank itself has worn out.

Worth repairing when

  • The water heater still has years of life left.
  • One part failed and everything else tests fine.
  • The tank is dry with no rust.

Time for a new water heater when

  • The tank itself is leaking.
  • There is rust at the seams or the base.
  • An older tank needs one repair after another.

Nothing is replaced until you have heard both options and made your choice.

How hard water and sediment affect a water heater

Most tap water contains some dissolved minerals, and hard water contains a lot. Heating the water makes those minerals settle on the bottom of the tank as a layer of sediment. Water trapped under that layer turns to steam, which causes the popping sound you hear.

  • Less hot water

    Sediment takes up space, so the tank holds less hot water.

  • Wasted energy

    The burner or element has to heat through the sediment.

  • A weaker tank

    Hot spots on the bottom of the tank wear it out sooner.

  • A clogged drain valve

    Loose sediment can block the drain valve when you try to flush the tank.

Flushing the tank once a year helps a lot, and a water softener slows the buildup before it starts.

Common tankless water heater problems

Tankless water heaters heat water as you use it, so they do not run out. They have their own common problems, and mineral buildup affects them even more than it affects a tank.

  • A short burst of cold water between hot water, often when faucets are turned on and off quickly.
  • An error code on the display, often caused by mineral buildup, venting or low water flow.
  • Weak hot water flow because the inlet screen is clogged with grit.
  • Not enough hot water because the unit is too small for several showers at once.

How to make your water heater last longer

  • Drain a few gallons from the valve at the bottom every year to remove sediment.
  • Once a year, lift the relief valve lever for a second to make sure it is not stuck.
  • Ask a plumber to check the anode rod every few years.
  • Keep the temperature hot enough for dishes but below scalding.
  • Keep paint cans, laundry and boxes well away from a gas burner and its vent.

What a water heater repair visit in Lubbock covers

On every water heater repair in Lubbock, the plumber checks the whole water heater, not only the part you called about.

  • Water connections

    The hot and cold pipes and fittings are checked for drips and corrosion.

  • The heat source

    The burner, pilot and thermocouple on gas models, or the elements and thermostats on electric models.

  • The vent

    On gas models, the vent pipe that carries exhaust gases outside.

  • The relief valve

    The safety valve that opens to let water out if heat or pressure in the tank climbs too far.

Water heater repair questions

  1. Why did my hot water stop overnight?

    On a gas water heater, the pilot light may have gone out. On an electric one, check for a tripped breaker or a failed element. Try resetting it once, and if that does not work, have it checked.

  2. Is a leaking water heater dangerous?

    It can flood the closet, and the water may be scalding. Close the cold water valve, turn off the heat and stay clear until someone has looked at it.

  3. How long does a tank water heater last?

    It depends on your water, how much hot water you use and how well it is maintained. The label shows when it was made, and an older unit with repeated problems may be worth replacing.

  4. Why does my water heater pop and rumble?

    Sediment at the bottom of the tank holds pockets of water that flash into steam. Flushing the tank often makes it quieter.

  5. What causes a rotten egg smell in hot water?

    Usually the anode rod is reacting with minerals in the water. Replacing the rod and flushing the tank normally fixes it.

  6. Can I flush my water heater myself?

    Some homeowners do, but scalding water and old drain valves that break easily make it risky. If you have any doubt, leave the flush to a plumber.

  7. What does the relief valve on a water heater do?

    It opens to release water if the temperature or pressure in the tank gets too high. A relief valve that drips or runs needs attention.

  8. Can I relight the pilot light myself?

    Most water heaters have the lighting steps printed on the label. Follow them step by step, and stop if the pilot goes out again or you notice a gas smell.

  9. Why is my hot water only lukewarm?

    The temperature dial set too low, a failed heating element or a thick layer of sediment are the usual causes.

  10. Do tankless water heaters need maintenance?

    Yes. Regular descaling keeps them efficient, and the inlet screen needs cleaning from time to time.

  11. Why do I run out of hot water so quickly?

    Sediment taking up space in the tank, a failed lower heating element or a water heater that is too small for the household are the usual reasons.

  12. Is some noise from a water heater normal?

    A soft ticking or hissing while it heats is normal. Loud cracking or banging points to sediment, and a steady dripping sound near the tank should be checked.

Water heater and gas line repairs

For water heater repair in Lubbock, tank or tankless, gas or electric, homeowners anywhere in the city can contact us.